Securing Cisco Router Access
The exec-timeout minutes seconds command terminates an inactive connection. Router (config)#line console 0 Router (config-line)#exec-timeout 5 20 Configuring Minimum Password …
connection between switch and router - Cisco Learning Network
The link between Router and Switch must be Straight Through cable but you use cross over cable.I think if you change the cable,you get ping between them.
AUX port VS console port - Cisco Learning Network
2. What is the AUX port used for? The AUX port lets you remotely connect to the router using a phone line and modem. It was used more in the past before the internet was everywhere. It’s a …
PC to Router via Console Connection - Cisco Learning Network
In Packet Tracer I'm trying to set up a connection between my PC and router but I want to use a console connection so i can configure the Router from the PC. I know this is simple but I'm not …
Crossover cable between a PC and a Router???? - Cisco Learning …
I guess the question was aiming at connecting a PC to a router via the console port which would then require a crossover cable. Thanks for your quick reply. ~Paul In regards to the …
Connecting Router to Router by using Serial , or Ethernet in LAN
Hi quang, Am I going to use Serial connection , or Ethernet connection for connecting between R-to-R in real life ? Which one is better ? In real deployments, and for labbing, I recommend you …
DTE and DCE connector? - Cisco Learning Network
The router (DTE) takes the smaller male connector and the CSU/DSU (DCE) takes the bigger female connector, this connects the two together and the clock rate and other details are …
Straight through and Crossover Cables - Cisco Learning Network
If you bypass the switch and connect your PC straight to the router, you would need a crossover cable instead. The same goes for switches - they usually connect to routers using straight …
Do you do a trunk link between the switch and the router or just …
If your router is providing first hop services to hosts on the network then you trunk from the switch to the router and configure sub-interfaces or BVI. If the switch is a multi-layer switch that …
error in connecting DCE and DTE serial cables
Hi Krishnapriyaa, Be sure to have a "serial interfaces" on those two routers . If not, pick another router model that supports serial interfaces. Best of luck.. Xmarks.